EVN feedback tool

Feedback for GJ014

Friend Site Result Problem Text
evn Shanghai Success None None
evn Shanghai Success None None
evn Shanghai Success None None
Zhukova, Lysakova Badary Success None None
Jonathan Quick Hartebeesthoek Minor failures RECE Receiver partially warmed up during experiment due to an electrical breaker failing and then re-cooled once power was restored to the helium compressor. No other known problems
LUIGI PAPALEO Noto Success None None
Daniel Sastre Walter Yebes Minor failures RECO Some problems to record properly from scan 38 to scan 43
Shumilova Svetloe Success None None
Ptitcin A. Zelenchukskaya Success None None
Jun Yang Onsala Minor failures None The first 10 minutes were out due to a change of antenna gearbox. Proper Tsys data were not available until the noise source were reset to normal MK4 calibration mode. At 9:15 UT, there was an error: ERROR sc -24 setcl: Mark 5B syncerr_gt_3. CONSIDER using fmset 's' option to fix. I tried to run fmset for a few times, while, MK5B was busy and refused to sync time during the gap (no recording).
Jimmy Cullen Jodrell_Bank Failure WIND Observation missed due to high winds
Geert Kuper Westerbork Success None None
K.Borkowski Torun Success None No known problems.
Jun Yang Onsala Minor failures None Switching on and off noise source had a long time delay (~20 seconds) in the first hour and so there were no Tsys measurements. After that, the bug was found and fixed by our software engineer. There was an error: 2014.294.09:15:50.22?ERROR sc -24 setcl: Mark 5B syncerr_gt_3, CONSIDER uisng fmset 's' option to fix. According to its suggestions, we tried to run fmset to fix it during the gap for a few times, while MK5B reported too busy to service request.
Uwe Bach Effelsberg Minor failures WIND There were two stops due to high wind at 15:00-15:30 UT 18:40-19:55 UT