| Friend | Site | Result | Problem | Text |
|---|---|---|---|---|
| mmost:jun-yang | Onsala | Success | No known problems. | |
| mmost:t6-operator | Tianma65 | Success | success | |
| mmost:surcis_srt | Sardinia | Success | TSYS | Missed scan no3030 because of pointing and focus check after sunset. Sr did not observe between 11:15 UT and 11:44 UT because of a power glitch that required to make the setup again. High Tsys in BBC01 LSB. |
| mmost:hh.vlbif | Hartebeesthoek | Minor failures | LATE | Receiver power supply fuse blew on antenna. Good data from 308-08:44 onwards following repair. No other known problems. |
| mmost:ys.miro | Yebes | Success | Tsys for last channel (8U) incorrect. Tsys calculated with hot/cold loads, preob takes 25sec, start recording 15sec late on each scan, some scans too short, e.g.: no0305 296 1949-052 248 16 NEUTR 21:27:55 21:27:55 21:28:00 21:28:00 0:05 498.7 * no0644 579 VR422201 289 55 NEUTR 22:34:10 22:35:01 22:35:11 22:35:11 0:10 1038.8 * no0840 807 3C119 75 62 NEUTR 23:24:12 23:26:54 23:26:54 23:26:54 0:00 1505.3 * etc. | |
| mmost:kvn.baek | KVN_Ulsan | Minor failures | LATE | 1. Set pointing offset (Az 0, El 0) & focus offset (0) for astrometry observation. No pointing correction was applied during the observation (intended). 2. Some sources are too low! (El ~ 5 deg). 3. UT20:30(start)-23:35: Original frequency setting in released vex was "64MHz x 8ch" for KVN, but it did not work due to VDIF output bug (theoretically it should be OK, but...). Operator manually changed $FREQ to "32MHz x 16ch", same as Ys one. Vex was restarted at UT 23:35. The recorded data before th |
| mmost:kvn.baek | KVN_Yonsei | Minor failures | TSYS, LATE | 1. Set pointing offset (Az 0, El 0) & focus offset (0) for astrometry observation. No pointing correction was applied during the observation (intended). 2. Some sources are too low! (El ~ 5 deg). 3. UT20:30(start)-23:35 (late start): Original frequency setting in released vex was "64MHz x 8ch" for KVN, but it did not work due to VDIF output bug (theoretically it should be OK, but...). Operator manually changed $FREQ to "32MHz x 16ch", same as Ys one. Vex was restarted at UT 23:35. The recorded d |
| mmost:kvn.baek | KVN_Tamna | Minor failures | LATE | 1. Set pointing offset (Az 0, El 0) & focus offset (0) for astrometry observation. No pointing correction was applied during the observation (intended). 2. Some sources are too low! (El ~ 5 deg). 3. UT20:30(start)-23:35 (late start): Original frequency setting in released vex was "64MHz x 8ch" for KVN, but it did not work due to VDIF output bug (theoretically it should be OK, but...). Operator manually changed $FREQ to "32MHz x 16ch", same as Ys one. Vex was restarted at UT 23:35. The recorded d |
| mmost:kvn.baek | KVN_Pyeongchang | Minor failures | TSYS, LATE | 1. Set pointing offset (Az 0, El 0) & focus offset (0) for astrometry observation. No pointing correction was applied during the observation (intended). 2. UT20:30(start)-23:35 (late start): Original frequency setting in released vex was "64MHz x 8ch" for KVN, but it did not work due to VDIF output bug (theoretically it should be OK, but...). Operator manually changed $FREQ to "32MHz x 16ch", same as Ys one. Vex was restarted at UT 23:35. The recorded data before this time may be meaningless. 3. |
| mmost:alastair.gunn | Jodrell_Bank | Success | No known problems. Used dummy RXG file. |